A virtual machine can use up to four virtual serial ports. You can connect the virtual serial port to a physical serial port or to a file on the host computer. You can also use a host-side-named pipe to set up a direct connection between two virtual machines or a connection between a virtual machine and an application on the host computer. In addition, you can use a port or vSPC URI to connect a serial port over the network.
Before you begin
Verify that the virtual machine is powered off.
Familiarize yourself with the media types for the port to access, vSPC connections, and any conditions that might apply. See Using Serial Ports with vSphere Virtual Machines.
To connect a serial port over a network, add a Firewall rule set. See Adding a Firewall Rule Set for Serial Port Network Connections.
- In the vSphere Client inventory, right-click the virtual machine and select Edit Settings.
- Click the Hardware tab and select Add.
- Select Serial Port and click Next.
- On the Serial Port Type page, select the type of media for the port to access.
Use physical serial port on the host
Click Next and select the port from the drop-down menu.
Output to file
Click Next and browse to the location of the file on the host to store the output of the virtual serial port.
Connect to named pipe
Click Next and type a name for the pipe in the Pipe Name field.
Select the Near end and Far end of the pipe from the drop-down menus.
Connect via network
Click Next and clickServer or Client and type the Port URI.
The URI is the remote end of the serial port to which the virtual machine's serial port should connect.
If vSPC is used as an intermediate step to access all virtual machines through a single IP address, select Use Virtual Serial Port Concentrator (vSPC) and type the vSPC URI location.
- (Optional) : Deselect Connect at power on if you do not want the parallel port device to be connected when the virtual machine powers on.
- (Optional) : Select Yield on poll.
Select this option only for guest operating systems that use serial ports in polled mode. This option prevents the guest from consuming excessive CPUs.
- Review the information on the Ready to Complete page and click Finish.
Establishing Serial Port Network Connections to a Client or Server Without Authentication Parameters
If you do not use vSPC and you configure your virtual machine with a serial port connected as a server with a
telnet://:12345 URI, you can connect to your virtual machine's serial port from your Linux or Windows operating system.
telnet yourESXiServerIPAddress 12345
Similarly, if you run the Telnet Server on your Linux system on port 23 (
telnet://yourLinuxBox:23), you configure the virtual machine as a client URI.
The virtual machine initiates the connection to your Linux system on port 23.