Use this task if you have two or more physical network adapters for iSCSI and you want to connect all of your NICs to a single vSphere standard switch. In this task, you add NICs and VMkernel adapters to an existing vSphere standard switch.

Before you begin

You must create a vSphere standard switch that maps an iSCSI VMkernel adapter to a single physical NIC designated for iSCSI traffic.

Procedure

  1. Log in to the vSphere Client, and select a host from the inventory panel.
  2. Click the Configuration tab and click Networking.
  3. Select the vSphere standard switch that you use for iSCSI and click Properties.
  4. Connect additional network adapters to the standard switch.
    1. In the standard switch Properties dialog box, click the Network Adapters tab and click Add.
    2. Select one or more NICs from the list and click Next.

      With dependent hardware iSCSI adapters, select only those NICs that have a corresponding iSCSI component.

    3. Review the information on the Adapter Summary page and click Finish.

      The list of network adapters reappears, showing the network adapters that the vSphere standard switch now claims.

  5. Create iSCSI VMkernel adapters for all NICs that you added.

    The number of VMkernel interfaces must correspond to the number of NICs on the vSphere standard switch.

    1. In the standard switch Properties dialog box, click the Ports tab and click Add.
    2. Select VMkernel and click Next.
    3. Under Port Group Properties, enter a network label, for example iSCSI, and click Next.
    4. Specify the IP settings and click Next.

      When you enter the subnet mask, make sure that the NIC is set to the subnet of the storage system it connects to.

    5. Review the information and click Finish.
    Caution:

    If the NIC you use with your iSCSI adapter, either software or dependent hardware, is not in the same subnet as your iSCSI target, your host cannot establish sessions from this network adapter to the target.

What to do next

Change the network policy for all VMkernel adapters, so that it is compatible with the network binding requirements. You can then bind the iSCSI VMkernel adapters to the software iSCSI or dependent hardware iSCSI adapters.