You can start an installation or upgrade script by typing boot command-line options at the ESXi installer boot command line.
About this task
At boot time you might need to specify options to access the kickstart file. You can enter boot options by pressing Shift+O in the boot loader. For a PXE boot installation, you can pass options through the
kernelopts line of the boot.cfg file. See About the boot.cfg File and PXE Booting the ESXi Installer.
ks=... option must be given, to specify the location of the installation script. Otherwise, a scripted installation or upgrade will not start. If
ks=... is omitted, the text installer will proceed.
Supported boot options are listed in Boot Options.
After you upgrade or migrate your host to ESXi 5.x, you cannot roll back to your version 4.x ESX or ESXi software. Back up your host before you perform an upgrade or migration, so that, if the upgrade or migration fails, you can restore your 4.x host.
- Start the host.
- When the ESXi installer window appears, press Shift+O to edit boot options.
- At the
runweaselcommand prompt, type ks=location of installation script plus boot command line options
You type the following boot options:
ks=http://00.00.00.00/kickstart/ks-osdc-pdp101.cfg nameserver=00.00.0.0 ip=00.00.00.000 netmask=255.255.255.0 gateway=00.00.00.000