You can add a VMkernel network adapter (NIC) on a vSphere standard switch to provide network connectivity for hosts and to handle the system traffic for vSphere vMotion, IP storage, Fault Tolerance, logging, Virtual SAN, and so on.
- Right-click Networking in the VMware Host Client inventory and click Add VMkernel NICs.
- On the Add new VMkernel interface page, configure the settings for the VMkernel adapter.
Port Group Label
Adding a new VMkernel NIC also adds a new port group. Specify a name for that port group.
Enter a VLAN ID to determine the VLAN for the network traffic of the VMkernel adapter to use.
Select IPv4, IPv6, or both.Note:
The IPv6 option does not appear on hosts that do not have IPv6 enabled.
- (Optional) : Expand the IPv4 settings section to select an option for obtaining IP addresses.
Use DHCP to obtain IP settings
IP settings are obtained automatically. A DHCP server must be present on the network.
Use static IP settings
Enter the IPv4 address and subnet mask for the VMkernel adapter.
The VMkernel Default Gateway and DNS server addresses for IPv4 are obtained from the selected TCP/IP stack.
- (Optional) : Expand the IPv6 settings section to select an option for obtaining IPv6 addresses.
Use DHCP to obtain IPv6 addresses. A DHCPv6 server must be present on the network.
Use router advertisement to obtain IPv6 addresses.
Static IPv6 Addresses
Click Add address to add a new IPv6 address.
Enter the IPv6 address and subnet prefix length.
- Select a virtual switch from the drop-down menu.
- Select a TCP/IP stack from the drop-down menu.
After you set a TCP/IP stack for the VMkernel adapter, you cannot change it. If you select the vMotion or the Provisioning TCP/IP stack, you can use only this stack to handle vMotion or for Provisioning traffic on the host. All VMkernel adapters for vMotion on the default TCP/IP stack are disabled for future vMotion sessions. If you use the Provisioning TCP/IP stack, VMkernel adapters on the default TCP/IP stack are disabled, and you cannot perform some operations including traffic Provisioning, such as virtual machine cold migration, cloning, and snapshot creation.
- (Optional) : Enable vMotion for the default TCP/IP stack on the host.
vMotion enables the VMkernel adapter to advertise itself to another host as the network connection where vMotion traffic is sent. It is not possible to use vMotion to perform migrations to selected hosts if the vMotion service is not enabled for any VMkernel adapter on the default TCP/IP stack, or if no adapters use the vMotion TCP/IP stack.
- Review your setting selections and click Create.