Create a vSphere Standard Switch to provide network connectivity for hosts, virtual machines, and to handle VMkernel traffic. Depending on the connection type that you want to create, you can create a new vSphere Standard Switch with a VMkernel adapter, only connect physical network adapters to the new switch, or create the switch with a virtual machine port group.
- In the vSphere Web Client, navigate to the host.
- Under Manage select Networking, and select Virtual switches.
- Click Add host networking.
- Select a connection type for which you want to use the new standard switch and click Next.
VMkernel Network Adapter
Create a new VMkernel adapter to handle host management traffic, vMotion, network storage, fault tolerance, or Virtual SAN traffic.
Physical Network Adapter
Add physical network adapters to an existing or a new standard switch.
Virtual Machine Port Group for a Standard Switch
Create a new port group for virtual machine networking.
- Select New standard switch and click Next.
- Add physical network adapters to the new standard switch.
- Under Assigned adapters, click Add adapters.
- Select one or more physical network adapters from the list.
- From the Failover order group drop-down menu, select from the Active or Standby failover lists.
For higher throughput and to provide redundancy, configure at least two physical network adapters in the Active list.
- Click OK.
- If you create the new standard switch with a VMkernel adapter or virtual machine port group, enter connection settings for the adapter or the port group.
Enter a label that indicates the traffic type for the VMkernel adapter, for example vMotion.
Set a VLAN ID to identify the VLAN that the network traffic of the VMkernel adapter will use.
Select IPv4, Ipv6 or both.
Select a TCP/IP stack. After you set a TCP/IP stack for the VMkernel adapter, you cannot change it later. If you select the vMotion or the Provisioning TCP/IP stack, you will be able to use only this stack to handle vMotion or Provisioning traffic on the host.
If you use the default TCP/IP stack, select from the available services.
Configure IPv4 and IPv6 settings.
Virtual machine port group
Enter a network Label or the port group, or accept the generated label.
Set the VLAN ID to configure VLAN handling in the port group.
- On the Ready to Complete page, click OK.
What to do next
You might need to change the teaming and failover policy of the new standard switch. For example, if the host is connected to an Etherchannel on the physical switch, you must configure the vSphere Standard Switch with Rout based on IP hash as a load balancing algorithm. See Teaming and Failover Policy for more information.
If you create the new standard switch with a port group for virtual machine networking, connect virtual machines to the port group.