After you have finished upgrading the Virtual SAN hosts, you can perform the disk format upgrade.
If you enable deduplication and compression on an existing Virtual SAN cluster, the on-disk format is automatically upgraded to the latest version, and this procedure is not required. You can avoid reformatting the disk groups twice. See Edit Virtual SAN Settings.
Verify that you are using the updated version of vCenter Server.
Verify that you are using the latest version of ESXi hosts.
Verify that the disks are in a healthy state. Navigate to the Disk Management page in the vSphere Web Client to verify the object status.
Verify that the hardware and software that you plan on using are certified and listed in the VMware Compatibility Guide Web site at http://www.vmware.com/resources/compatibility/search.php.
Verify that you have enough free space to perform the disk format upgrade. Run the RVC command, vsan.whatif_host_failures, to determine whether you have enough capacity to successfully finish the upgrade or perform a component rebuild, in case you encounter any failure during the upgrade.
Verify that your hosts are not in maintenance mode. When upgrading the disk format, you should not place the hosts in maintenance mode. When any member host of a Virtual SAN cluster enters maintenance mode, the available resource capacity in the cluster is reduced because the member host no longer contributes capacity to the cluster and the cluster upgrade might fail.
Verify that there are no component rebuilding tasks currently in progress in the Virtual SAN cluster. See Monitor the Resynchronization Tasks in the Virtual SAN Cluster.
- Navigate to the Virtual SAN cluster in the vSphere Web Client.
- Click the Manage tab and click Settings.
- Under Virtual SAN, select General.
- Under On-disk Format Version, click Upgrade.
- Click Yes on the Upgrade dialog to perform the upgrade of the on-disk format.
Virtual SAN performs a rolling reboot of each disk group in the cluster. The On-disk Format Version column displays the disk format version of storage devices in the cluster. The Disks with outdated version column indicates the number of devices using the new format. When the upgrade is successful, the Disks with outdated version will be 0.
If a failure occurs during the upgrade, you can check the Resyncing Components page in the vSphere Web Client. Wait for all resynchronizations to complete, and run the upgrade again. You also can check the cluster health using the health service. After you have resolved any issues raised by the health checks, you can run the upgrade again.