The CPU (MHz) chart displays CPU usage for the 10 clusters in the data center with the most CPU usage.

This chart is located in the Clusters view of the Datacenters Performance tab.

Table 1. Data Counters
Chart Label Description
<cluster>

Amount of CPU currently in use by the cluster. The active CPU usage is approximately equal to the ratio of the used CPU cycles to the available CPU cycles.

The maximum possible value is the frequency of the processors multiplied by the number of cores. For example, a two-way SMP virtual machine using 4000MHz on a host that has four 2GHz processors is using 50% of the CPU (4000 ÷ 4 × 2000) = 0.5).

  • Counter: usagemhz
  • Stats Type: Rate
  • Unit: MegaHertz (MHz)
  • Rollup Type: Average (Minimum/Maximum)
  • Collection Level: 1 (4)

Chart Analysis

A short spike in CPU usage indicates that you are making the best use of cluster resources. However, if the value is constantly high, the CPU demanded is likely greater than the CPU capacity available. A high CPU usage value can lead to increased ready time and processor queuing of the virtual machines on the hosts in the cluster.

If performance is impacted, consider taking the following actions.

Table 2. CPU Performance Enhancement Advice
# Resolution
1 Verify that VMware Tools is installed on each virtual machine.
2 If the cluster is not a DRS cluster, enable DRS. To enable DRS, perform the following tasks:
  1. Select the cluster, and click the Configure tab.
  2. Under Services, click vSphere DRS.
  3. click Edit.

    An Edit Cluster Settings dialog box opens.

  4. Click Turn ON vSphere DRS, and click OK.
3

If the cluster is a DRS cluster:

  • Increase the number of hosts, and migrate one or more virtual machines to the new host.
  • Check the aggressiveness threshold. If the value is low, increase the threshold. This might help avoid hot spots in the cluster.
4 Migrate one or more virtual machines to a new host.
5 Upgrade the physical CPUs or cores on each host in the cluster if necessary.
6 Enable CPU-saving features, such as TCP Segmentation Offload.
7 Replace software I/O with dedicated hardware, such as iSCSI HBAs or TCP Segmentation Offload NICs.