To ensure optimal Fault Tolerance results, you should follow certain best practices.
The following recommendations for host and networking configuration can help improve the stability and performance of your cluster.
Hosts running the Primary and Secondary VMs should operate at approximately the same processor frequencies, otherwise the Secondary VM might be restarted more frequently. Platform power management features that do not adjust based on workload (for example, power capping and enforced low frequency modes to save power) can cause processor frequencies to vary greatly. If Secondary VMs are being restarted on a regular basis, disable all power management modes on the hosts running fault tolerant virtual machines or ensure that all hosts are running in the same power management modes.
Host Networking Configuration
The following guidelines allow you to configure your host's networking to support Fault Tolerance with different combinations of traffic types (for example, NFS) and numbers of physical NICs.
Distribute each NIC team over two physical switches ensuring L2 domain continuity for each VLAN between the two physical switches.
Use deterministic teaming policies to ensure particular traffic types have an affinity to a particular NIC (active/standby) or set of NICs (for example, originating virtual port-id).
Where active/standby policies are used, pair traffic types to minimize impact in a failover situation where both traffic types will share a vmnic.
Where active/standby policies are used, configure all the active adapters for a particular traffic type (for example, FT Logging) to the same physical switch. This minimizes the number of network hops and lessens the possibility of oversubscribing the switch to switch links.
FT logging traffic between Primary and Secondary VMs is unencrypted and contains guest network and storage I/O data, as well as the memory contents of the guest operating system. This traffic can include sensitive data such as passwords in plaintext. To avoid such data being divulged, ensure that this network is secured, especially to avoid 'man-in-the-middle' attacks. For example, you could use a private network for FT logging traffic.
vSphere Fault Tolerance can function in clusters with nonuniform hosts, but it works best in clusters with compatible nodes. When constructing your cluster, all hosts should have the following configuration:
Common access to datastores used by the virtual machines.
The same virtual machine network configuration.
The same BIOS settings (power management and hyperthreading) for all hosts.
Run Check Compliance to identify incompatibilities and to correct them.
To increase the bandwidth available for the logging traffic between Primary and Secondary VMs use a 10Gbit NIC, and enable the use of jumbo frames.
You can select multiple NICs for the FT logging network. By selecting multiple NICs, you can take advantage of the bandwidth from multiple NICs even if all of the NICs are not dedicated to running FT.
Store ISOs on Shared Storage for Continuous Access
Store ISOs that are accessed by virtual machines with Fault Tolerance enabled on shared storage that is accessible to both instances of the fault tolerant virtual machine. If you use this configuration, the CD-ROM in the virtual machine continues operating normally, even when a failover occurs.
Avoid Network Partitions
A network partition occurs when a vSphere HA cluster has a management network failure that isolates some of the hosts from vCenter Server and from one another. See Network Partitions. When a partition occurs, Fault Tolerance protection might be degraded.
In a partitioned vSphere HA cluster using Fault Tolerance, the Primary VM (or its Secondary VM) could end up in a partition managed by a master host that is not responsible for the virtual machine. When a failover is needed, a Secondary VM is restarted only if the Primary VM was in a partition managed by the master host responsible for it.
To ensure that your management network is less likely to have a failure that leads to a network partition, follow the recommendations in Best Practices for Networking.
Using vSAN Datastores
vSphere Fault Tolerance can use vSAN datastores, but you must observe the following restrictions:
A mix of vSAN and other types of datastores is not supported for both Primary VMs and Secondary VMs.
vSAN metro clusters are not supported with FT.
To increase performance and reliability when using FT with vSAN, the following conditions are also recommended.
vSAN and FT should use separate networks.
Keep Primary and Secondary VMs in separate vSAN fault domains.