Configure Dynamic or Static Discovery for iSCSI and iSER

With dynamic discovery, each time the initiator contacts a specified iSCSI storage system, it sends the SendTargets request to the system. The iSCSI system responds by supplying a list of available targets to the initiator. In addition to the dynamic discovery method, you can use static discovery and manually enter information for the targets.

When you set up static or dynamic discovery, you can only add new iSCSI targets. You cannot change any parameters of an existing target. To make changes, remove the existing target and add a new one.

Prerequisites

Required privilege: Host.Configuration.Storage Partition Configuration

Procedure

1. Navigate to the host.
2. Click the Configure tab.
3. Under Storage, click Storage Adapters, and select the adapter (vmhba#) to configure.
4. Configure the discovery method.

   Discovery Method	Description
   Dynamic Discovery	Click Dynamic Discovery and click Add. Enter the IP address or DNS name of the storage system and click OK. Rescan the iSCSI adapter. After establishing the SendTargets session with the iSCSI system, your host populates the Static Discovery list with all newly discovered targets.
   Static Discovery	Click Static Discovery and click Add. Enter the target’s information and click OK Rescan the iSCSI adapter.