Add Devices to the Disk Group

When you configure vSAN to claim disks in manual mode, you can add additional local devices to existing disk groups.

The devices must be the same type as the existing devices in the disk groups, such as SSD or magnetic disks.

Procedure

1. Navigate to the vSAN cluster.
2. Click the Configure tab.
3. Under vSAN, click Disk Management.
4. Select the disk group, and click the Add Disks.
5. Select the device that you want to add and click Add.
   If you add a used device that contains residual data or partition information, you must first clean the device. For information about removing partition information from devices, see Remove Partition From Devices. You can also run the host_wipe_vsan_disks RVC command to format the device. For more information about RVC commands, see the RVC Command Reference Guide.

What to do next

Verify that the vSAN Disk Balance health check is green. If the Disk Balance health check issues a warning, perform a manual rebalance operation during off-peak hours. For more information, see "Manual Rebalance" in vSAN Monitoring and Troubleshooting.