Set Up a VMkernel Network for vSAN

To enable the exchange of data in the vSAN cluster, you must provide a VMkernel network adapter for vSAN traffic on each ESXi host.

Procedure

1. Navigate to the host.
2. Click the Configure tab.
3. Under Networking, select VMkernel adapters.
4. Click Add Networking to open the Add Networking wizard.
5. On the Select connection type page, select VMkernel Network Adapter and click Next.
6. On the Select target device page, configure the target switching device.
7. On the Port properties page, select vSAN service.
8. Complete the VMkernel adapter configuration.
9. On the Ready to complete page, verify that vSAN is Enabled in the status for the VMkernel adapter, and click Finish.

Results

vSAN network is enabled for the host.

What to do next

You can enable vSAN on the host cluster.