The following NIC teaming configurations illustrate typical vSAN networking scenarios. What to read next Configuration 1: Single vmknic, Route Based on Physical NIC LoadYou can configure basic Active/Active NIC Teaming with the Route based on Physical NIC Load policy for vSAN hosts. Use a vSphere Distributed Switch (vDS). Configuration 2: Multiple vmknics, Route Based on Originating Port ID You can use two non-routable VLANs that are logically and physically separated, to produce an air-gap topology. Configuration 3: Dynamic LACPYou can configure a two-port LACP port channel on a switch and a two-uplink Link Aggregation Group on a vSphere distributed switch. Configuration 4: Static LACP – Route Based on IP Hash You can use a two-port LACP static port-channel on a switch, and two active uplinks on a vSphere Standard Switch. Parent topic: Advanced NIC Teaming