Remote Hot Cloning of Powered Оn Source Machines That Are Running Windows

You can use the Conversion wizard to set up conversion tasks and Converter Standalone components perform all the cloning tasks.

The following workflow is an example of remote hot cloning in which the powered on machine that is being cloned experiences no downtime.

Note: With Converter Standalone 6.6, you can convert source Windows machines that have no direct access to the destination ESXi server by using the proxy mode feature. The feature is available only for conversion of powered on Windows sources to managed destinations.

1. Converter Standalone prepares the source machine for the conversion.

   Converter Standalone installs the agent on the source machine, and obtains information about the hardware and the operating system of the source machine.

   
   
   
2. Converter Standalone creates a virtual machine on the destination machine.
   
   
3. Converter Standalone agent takes a snapshot of the source volumes and copies the source volumes machine to the destination hypervisor.

   If the proxy mode feature is off, the data traffic passes from the source machine directly to the destination server.

   
   
   

   If the proxy mode feature is on, the data traffic passes from the source machine through the Converter Standalone server to the destination server.

   
   
   
4. Converter Standalone finishes the conversion process.

   The agent installs the drivers required for the operating system to start in a virtual machine and personalizes the virtual machine (changes the IP information, for example).

   
   
   
5. Optionally, Converter Standalone uninstalls the agent from the source machine.

   The virtual machine is ready to run on the destination server.