The RSA SecurID server must be configured with information about the Directories Management appliance as the authentication agent. The information required is the host name and the IP addresses for network interfaces.
Verify that one of the following RSA Authentication Manager versions is installed and functioning on the enterprise network: RSA AM 6.1.2, 7.1 SP2 and later, and 8.0 and later. The Directories Management server uses AuthSDK_Java_v18.104.22.1682.06_03_11_03_16_51 (Agent API 8.1 SP1), which only supports the preceding versions of RSA Authentication Manager (the RSA SecurID server). For information about installing and configuring RSA Authentication Manager (RSA SecurID server), see RSA documentation.
- On a supported version of the RSA SecurID server, add the Directories Management connector as an authentication agent. Enter the following information.
The host name of Directories Management.
The IP address of Directories Management.
Alternate IP address
If traffic from the connector passes through a network address translation (NAT) device to reach the RSA SecurID server, enter the private IP address of the appliance.
- Download the compressed configuration file and extract the sdconf.rec file.
Be prepared to upload this file later when you configure RSA SecurID in Directories Management.
What to do next
Go to the administration console and in the Identity & Access Management tab Setup pages, select the connector and in the AuthAdapters page configure SecurID.