You can create a single properties file that contains property values that are used by multiple agents.

About this task

To enable mass agent deployment, you create an agent.properties file that defines the agent properties required for the agent to start up and connect with the vRealize Hyperic server. If you supply the necessary information in the properties file, each vRealize Hyperic agent will locate its setup configuration at startup, rather than prompting you for the location. You can create a standard agent profile that you can copy to the agent installation, or to a location available to the agent installation.

Prerequisites

Verify that the prerequisites in Install Multiple vRealize Hyperic Agents Simultaneously have been satisfied.

Procedure

  1. Create an agent.properties file in HqUserHome/.hq on the install server.
  2. Configure the properties as required. The minimum configuration is the IP address and port of the vRealize Hyperic install server.

    Do not specify values for the agent listen address and port. At first startup, if explicit values for IP address and port are not set, the vRealize Hyperic agent - which detects the network interfaces on the platform - uses the first detected interface as its listen address, and port 2144 or 2443 as its listen port, depending on whether you configure the agent for plain text or SSL communications.

  3. Save your configurations.

Results

The first time that the agents are started, they read the agent.properties file to identify the server connection information, will connect to the server and register themselves.

What to do next

Perform remote agent installations. See Deploy and Start Multiple Agents One-By-One or Deploy and Start Multiple Agents Simultaneously.