vRealize Operations Manager supports Internet Protocol version 6 (IPv6), the network addressing convention that will eventually replace IPv4. Use of IPv6 with vRealize Operations Manager requires that certain limitations be observed.
All vRealize Operations Manager cluster nodes, including remote collectors, must have IPv6 addresses. Do not mix IPv6 and IPv4.
All vRealize Operations Manager cluster nodes, including remote collectors, must be vApp or Linux based.
Use global IPv6 addresses only. Link-local addresses are not supported.
If any nodes use DHCP, your DHCP server must be configured to support IPv6.
DHCP is only supported on data nodes and remote collectors. Master nodes and replica nodes still require fixed addresses, which is true for IPv4 as well.
Your DNS server must be configured to support IPv6.
When adding nodes to the cluster, remember to enter the IPv6 address of the master node.
When registering a VMware vCenter instance within vRealize Operations Manager, place square brackets around the IPv6 address of your VMware vCenter Server system if vCenter is also using IPv6.
Note that, even when vRealize Operations Manager is using IPv6, vCenter Server may still have an IPv4 address. In that case, vRealize Operations Manager does not need the square brackets.
You cannot register an Endpoint Operations Management agent in an environment that supports both IPv4 and IPv6. In the event that you attempt to do so, the following error appears:
Connection failed. Server may be down (or wrong IP/port were used). Waiting for 10 seconds before retrying.