Activate Continuous Availability in vRealize Operations

You can activate continuous availability (CA) for vRealize Operations to protect your data if there is one or more node failures.

Note: If the cluster is running, activating CA restarts the cluster.

You can activate CA in the vRealize Operations cluster at the installation time or after vRealize Operations is up and running. Adding CA at installation is less intrusive because the cluster has not yet started.

Prerequisites

• Create nodes by deploying the vRealize Operations vApp.
• Create and configure the primary node.
• Create and configure the witness node.
  Note: vRealize Operations can have only one witness node in its cluster. While deploying an OVA file, you can select the recommended CPU/RAM configuration for the witness node.
• Create and configure one data node with a static IP address.
• Note the fully qualified domain name (FQDN) or IP address of the primary node.

Procedure

1. In a Web browser, navigate to the primary node administration interface.
   https://primary-node-name-or-ip-address/admin
2. Enter the vRealize Operations administrator user name of admin.
3. Enter the vRealize Operations administrator password and click Log In.
4. Under Continuous Availability, click Activate CA.
   The Continuous Availability wizard opens. The Witness node exists outside the fault domains. The primary node is already assigned to Fault Domain 1.

   Note: You can enter names for each Fault Domain during installation. You can also edit the fault domain names after activating continous availability.
5. To create a pair with the primary node, drag the data nodes to Fault Domain 2.
   Note: You can add a maximum of 16 data nodes including the primary node and divide them between the fault domains to create eight pairs.
6. Click Ok.