You can use Control Center to change the default Orchestrator behavior. Reconfiguring AuthenticationAfter you set up the authentication method during the initial configuration of Control Center, you can change the authentication provider or the configured parameters at any time. Export the Orchestrator ConfigurationControl Center provides a mechanism to export the Orchestrator configuration settings to a local file. You can use the mechanism to take a snapshot of your system configuration at any moment and import this configuration into a new Orchestrator instance. Import the Orchestrator ConfigurationYou can restore a previously exported system configuration after you reinstall Orchestrator or if a system failure occurs. Configuring the Workflow Run PropertiesBy default, you can run up to 300 workflows per node and up to 10,000 workflows can be queued if the number of actively running workflows is reached. Orchestrator Log FilesVMware Technical Support routinely requests diagnostic information when you submit a support request. This diagnostic information contains product-specific logs and configuration files from the host on which the product runs. Add Network Interface ControllersvRealize Orchestrator supports multiple network interface controllers (NICs). After installation, you can add NICs to the Orchestrator appliance. Configure Static RoutesWhen adding NICs to a vRealize Orchestrator installation, if you need static routes, open a command prompt session to configure them.