You can configure service groups by performing these steps.

Procedure

  1. Log in to the NetScaler load balancer and navigate to NetScaler > Traffic Management > Load Balancing > Service Groups.
  2. Click Add and configure the service groups as outlined in this table.
    Table 1. Configure Service Groups
    Name Health Monitors Protocol SG Members Address Port
    vRealize Automation vRealize Automation SSL Bridge VA1

    VA2

    VA3

    IP Address 443
    vRealize Orchestrator
    Note: Use only for external vRealize Orchestrator instances.
    vRealize Orchestrator SSL Bridge VA1

    VA2

    VA3

    IP Address 443
    Workspace ONE Access Workspace ONE Access SSL Bridge VA1

    VA2

    VA3

    IP Address 443

Results

The configuration should look similar to this screen: