從第 0 層服務路由器中使用 CLI 來確認 BGP 已連線通往芳鄰。

必要條件

確認已設定 BGP。請參閱在管理程式模式中的第 0 層邏輯路由器上設定 BGP。

程序

  1. 登入 NSX Manager CLI。
  2. 在 NSX Edge 上執行 get logical-routers 命令，以尋找第 0 層服務路由器的 VRF 號碼。 
    nsx-edge-1> get logical-routers
Logical Router
UUID        : 736a80e3-23f6-5a2d-81d6-bbefb2786666
vrf         : 0
type        : TUNNEL

Logical Router
UUID        : 421a2d0d-f423-46f1-93a1-2f9e366176c8
vrf         : 5
type        : SERVICE_ROUTER_TIER0

Logical Router
UUID        : f3ce9d7d-7123-47d6-aba6-45cf1388ca7b
vrf         : 6
type        : DISTRIBUTED_ROUTER

Logical Router
UUID        : c8e64eff-02b2-4462-94ff-89f3788f1a61
vrf         : 7
type        : SERVICE_ROUTER_TIER1

Logical Router
UUID        : fb6c3f1f-599f-4421-af8a-99692dff3dd4
vrf         : 8
type        : DISTRIBUTED_ROUTER
  3. 執行 vrf <number> 命令，以進入第 0 層服務路由器內容。 
    nsx-edge-1> vrf 5
nsx-edge1(tier0_sr)>
  4. 確認 BGP 狀態為 Established, up。
    get bgp neighbor 
    BGP neighbor: 192.168.100.254   Remote AS: 64511
BGP state: Established, up
Hold Time: 180s   Keepalive Interval: 60s
Capabilities:
         Route Refresh: advertised and received
         Address Family: IPv4 Unicast:advertised and received
         Graceful Restart: none
         Restart Remaining Time: 0
Messages: 28 received, 31 sent
Minimum time between advertisements: 30s (default)
For Address Family IPv4 Unicast:advertised and received
         Route Refresh: 0 received, 0 sent
         Prefixes: 2 received, 2 sent, 2 advertised
1 Connections established, 2 dropped
Local host: 192.168.100.3, Local port: 179
Remote host: 192.168.100.254, Remote port: 33044

下一步

檢查來自外部路由器的 BGP 連線。請參閱確認第 0 層路由器上的南北向連線和路由重新分配。