Upgrade the DR Setup

To upgrade a DR-enabled SASE Orchestrator pair, follow the steps below.

To upgrade a DR-enabled VCO pair:

Note: If the Orchestrator upgrade is from 2.X -> 3.2.X, run dr-standby-schema.sh on the Standby before starting the upgrade.

1. Prepare for the Upgrade. For instructions, go to Step 1: Prepare for the Orchestrator Upgrade of the section titled, Upgrade an Orchestrator with DR Deployment.
2. Proceed with the Orchestrator Upgrade. For instructions, go to Step 4: Proceed with the Orchestrator Upgrade of the section titled, Upgrade an Orchestrator with DR Deployment.