Default values for the Connectivity Polling setting lists the Connectivity Polling setting parameters.
Parameter |
Default value |
Description |
---|---|---|
AnalysisMode |
ENABLED,DISABLED Default: ENABLED |
Enables or disables connectivity polling and the subsequent availability analysis of the polled data. |
MaximumLatency |
0 to 3600 milliseconds Default: 0 milliseconds |
Applicable to ICMP polling:Maximum round-trip time between an ICMP request and the subsequent ICMP response. MaximumLatency = 0 disables the ICMP latency feature, and MaximumLatency = <non-zero value> enables the ICMP latency feature. |
PingControl |
ENABLED,DISABLED Default: DISABLED |
Applicable to ICMP polling:Enables or disables PingInterval and PingRetries. When PingControl is enabled, you can use PingInterval and PingRetries to control ICMP polling. |
PingInterval |
20 to 3600 seconds Default: 20 seconds |
Applicable to ICMP polling:Time between successive ICMP polls. |
PingRetries |
0 to 10 retries Default: 3 |
Applicable to ICMP polling:Number of retry polls to perform when the initial ICMP poll fails. |
PollingInterval |
30 to 3600 seconds Default: 240 seconds |
Applicable to SNMP polling:Time between successive SNMP polls. |
Retries |
0 to 10 retries Default: 3 |
Applicable to SNMP polling:Number of retry polls to perform when the initial SNMP poll fails. |
Timeout |
10 to 10000 milliseconds Default: 700 milliseconds |
Applicable to both ICMP and SNMP polling:Amount of time to wait for the poll response before the first poll request times out. The timeout value doubles for each successive retry. For Timeout=700 msec (0.7 sec) and Retries=3:
|
Default values for the Connectivity Polling for IPv6 Addresses setting lists the Connectivity Polling for IPv6 Addresses setting parameters.
Parameter |
Default value |
Description |
---|---|---|
AnalysisMode |
ENABLED,DISABLED Default: ENABLED |
Enables or disables connectivity polling and the subsequent availability analysis of the polled data. |
PollingInterval |
30 to 3600 seconds Default: 240 seconds |
Applicable to both ICMP and SNMP polling:Time between successive connectivity polls. |
Retries |
0 to 10 retries Default: 3 |
Applicable to both ICMP and SNMP polling:Number of retry polls to perform when the initial poll fails. |
Timeout |
10 to 10000 milliseconds Default: 700 milliseconds |
Applicable to both ICMP and SNMP polling:Amount of time to wait for the poll response before the first poll request times out. The timeout value doubles for each successive retry. For Timeout=700 msec (0.7 sec) and Retries=3:
|