The ISIS CISCO CLI Setting determines the polling intervals that are used by Network Protocol Manager for IS-IS to establish Telnet, SSH1, or SSH2 sessions to the Cisco devices and invoke the following CLI command:

show clns neighbors detail

The command provides the target device’s CLNS neighbor interface connections (neighbor IP addresses).

ISIS CISCO CLI Setting parameters and their values lists the ISIS CISCO CLI Setting parameters.

Table 1. ISIS CISCO CLI Setting parameters and their values

Parameter

Values

Description

AnalysisMode

ENABLEDDISABLED

Default: ENABLED

Enables or disables:

  1. The Network Protocol Manager for IS-IS polling of IS-IS interface (ISISInterface) data.

  2. The subsequent analysis of the polled data to determine the status of IS-IS sessions.

PollingInterval

30 to 3600 seconds

Default: 240 seconds

Sets the time between successive polls.

Retries

0 to 10 retries

Default: 3

Sets the number of retry polls to perform when the initial poll fails.

Timeout

10 to 10000 milliseconds

Default: 700 milliseconds

Sets the amount of time to wait for the poll response before the first poll request times out. The timeout value doubles for each successive retry.

For Timeout=700 msec (0.7 sec) and Retries=3:

  • 0.7 seconds for first retry

  • 1.4 seconds for second retry

  • 2.8 seconds for third retry