Configure the built-in trap receiver

The VoIP Availability Manager built-in trap receiver sends traps to enablement packs as described in “Built-in trap receiver” on page 81. By default, the built-in trap receiver is disabled, and should be enabled only when the Avaya Enablement Pack, Cisco Enablement Pack, Nortel Enablement Pack, or VoIP Performance Manager Integration Pack is installed.

To configure the VoIP Availability Manager built-in trap receiver, follow the procedure in “Enabling trap reception” on page 36 to enable the built-in trap receiver and to set its port number to the destination port specified for VoIP Availability Manager in the trap exploder’s trapd.conf file.