r2621(config)#access-list 100 permit ip ? A.B.C.D Source address any Any source host host A single source host r2621(config)#access-list 100 permit ip % Incomplete command. r2621(config)#access-list 100 permit ip ? A.B.C.D Source address any Any source host host A single source host r2621(config)#access-list 100 permit ip host 1.1.1.0 ? A.B.C.D Destination address any Any destination host host A single destination host r2621(config)#access-list 100 permit ip host 1.1.1.0 any ? dscp Match packets with given dscp value fragments Check non-initial fragments log Log matches against this entry log-input Log matches against this entry, including input interface precedence Match packets with given precedence value time-range Specify a time-range tos Match packets with given TOS value <cr>
AclExtendedRule attributes lists attributes supported in AclExtendedRule.
Display Name |
Type |
Description |
---|---|---|
Ack |
Boolean |
ACK tcp-flag. |
AclRuleDescription |
String |
User description of rule. (Most devices do not implement this.) |
Action |
String |
Action to take on packet if the rule matches. |
Dscp |
Integer |
Diff-serve code point. Small integer value. |
DstIpAddress |
IpAddressString |
Destination IP address (IPV4 or IPV6). |
DstIpCIDR |
IpAddressString |
Constructed IP conglomerate used for comparisons. |
DstIpNetMask |
String |
Destination IP Net Mask. (These are true Net Masks, not Wildcard entries). |
DstMac |
String |
Destination MAC for layer 2 packets. |
DstMacMACADDR |
String |
Constructed destination MAC for comparisons. |
DstPortList |
ListObject |
Destination port low range or single port value. |
DynamicName |
String |
Name of dynamic ACL. |
EspSpi |
String |
Value of IPSEC Security Parameter Index |
EthernetType |
Integer |
Ethernet type code. |
Fin |
Boolean |
Fin tcp-flag. |
ForwardingClass |
String |
Current forwarding class of packet. |
FragOffsetRange |
String |
Frag offset range. |
IcmpCode |
Integer |
ICMP code for ICMP packets. |
IcmpMessage |
String |
ICMP message for ICMP packets. |
IcmpType |
Integer |
Type code for ICMP packets. |
IgmpTypeList |
ListObject |
IGMP type code for IGMP packets. |
IpOptionsList |
ListObject |
List of IP options specified by this rule. |
IpPrecedence |
Integer |
IP precedence value. |
IpProtocolList |
ListObject |
Ip protocol list or range |
IsEstablished |
Boolean |
Boolean indication a TCP connection is established. |
IsFragment |
Boolean |
Boolean indicating packet is a fragment. |
LogInput |
Boolean |
Enable the logging of input interface |
LogPackets |
Boolean |
Boolean indicating packets should be logged. |
MacPrecedence |
Integer |
MAC precedence value. |
MatchCount |
Long |
The device rule counter for this rule. |
PacketLength |
Integer |
Packet length of IP packet. |
Psh |
Boolean |
Psh tcp-flag. |
RedirectPort |
Integer |
Port number packets matching packets should be redirected to |
RejectCode |
Integer |
ICMP reject code that should be sent when packets match rule. |
Rst |
Boolean |
Reset tcp-flag |
RuleNumber |
Integer |
Rule number with the ACL. |
SetForwardingClass |
String |
Set matching packet’s forwarding class to specified field. |
SetLossPriority |
String |
Set matching packets loss priority to specified field. |
SetRateLimiter |
String |
Set matching packets rate limiter to specified field. |
SrcIpAddress |
IpAddressString |
Source IP address in rule (IPV4 or IPV6). |
SrcIpCIDR |
IpAddressString |
Constructed IP/mask conglomerate for address comparisons. |
SrcIpNetMask |
String |
Source IP Net Mask. (These are true Net Masks, not Wildcard entries). |
SrcMac |
String |
Source MAC for layer 2 packets. |
SrcMacMACADDR |
String |
Constructed source MAC operator for comparisons. |
SrcPortList |
ListObject |
List of source ports or port ranges |
Syn |
Boolean |
Syn tcp-flag. |
TimeRange |
String |
Name of time range association. (Cisco) |
TypeOfServiceList |
ListObject |
List of IP type of service values. |
Urg |
Boolean |
Urg tcp-flag. |