CLI commands invoked on Juniper M/T devices

The CLI show commands for Juniper M/T devices are listed and described in CLI commands for discovery on Juniper M/T devices.

Table 1. CLI commands for discovery on Juniper M/T devices

Command	Description	Comment
CLI commands for MPLS discovery
show mpls lsp detail ingress	Shows the configured and active dynamic LSPs that originate from the device.
show mpls interfaces	Shows the MPLS interfaces, their state, and administrative groups.
show mpls lsp transit up | match Up	For transit LSPs, shows the incoming and outgoing labels and LSPID.
show mpls lsp ingress detail up |     match “.”	For ingress LSPs, shows the LSPID, the LSP name, and the full LSP path.
show rsvp session ingress	For RSVP-based ingress LSPs, shows the outgoing label, the LSPID, and the LSP name.
show rsvp neighbor detail | match via	For each RSVP neighbor, shows the interface that talks to that neighbor and the IP of the facing interface on that neighbor.
show route forwarding-table family     mpls	Shows the MPLS forwarding table, including the incoming and outgoing labels and the outgoing interface. Also identifies load balancing LSPs.
show ldp neighbor	Shows peer LDP speakers, their IP address, and the interface used to exchange labels with them.
show ldp database | match "--|/32"	Shows the LDP database—only /32 routes (and headers).
show ldp route | match /32	Shows the LDP routes—only /32 routes (and headers).
show ldp session detail	Shows LDP session information.	Used to discovernon-targeted LDP adjacencies.
CLI commands for L2VPN discovery
show ldp session detail	Shows LDP session information.	Used to discovertargeted LDP adjacencies.
show vpls connections extensive	Shows VPLS connection information.	Used to discover VPLS instances, and to discover and map VLANs to discovered VPLS instances. Note: A BGP-signaled VPLS is also SNMP-discovered; CLI-discovered values do not overwrite SNMP-discovered values.
show interfaces	Shows status information about the management Ethernet and internal Ethernet interfaces.
CLI commands for L3VPN discovery
show route table <vrf name>.inet.0 |     match bgp	Shows the BGP entries in the routing table of each VRF.
show routeinstance detail | match “^[^ _]*:$|Router|Type:|- target|Interfaces:|.*/.*/”
show mvpn instance	Used to identify both the multicast group and its relation with the P-tunnel (P2MP LSP).
CLI commands for BGP route reflector discovery (JunOS)
show bgp neighbors | match “^Peer:|Type:”