A tier-0 logical router provides a gateway service between the logical and physical network.

NSX Cloud Note: If using NSX Cloud, see How to use NSX Features with the Public Cloud for a list of auto-generated logical entities, supported features, and configurations required for NSX Cloud.

An Edge node can support only one tier-0 gateway or logical router. When you create a tier-0 gateway or logical router, make sure you do not create more tier-0 gateways or logical routers than the number of Edge nodes in the NSX Edge cluster.

When you add a tier-0 logical router, it is important that you map out the networking topology you are building.

Figure 1. Tier-0 Logical Router Topology
Diagram of tier-0 and tier-1 routers and switches

For simplicity, the sample topology shows a single tier-1 logical router connected to a single tier-0 logical router hosted on a single NSX Edge node. Keep in mind that this is not a recommended topology. Ideally, you should have a minimum of two NSX Edge nodes to take full advantage of the logical router design.

The tier-1 logical router has a web logical switch and an app logical switch with respective VMs attached. The router-link switch between the tier-1 router and the tier-0 router is created automatically when you attach the tier-1 router to the tier-0 router. Thus, this switch is labeled as system generated.

In some scenarios, external clients send ARP queries for MAC addresses bound to loopback or IKE IP ports. However, loopback and IKE IP ports do not have MAC addresses and cannot handle such queries. Proxy ARP is implemented on the uplink and centralized service ports of a tier-0 logical router to handle ARP queries on behalf of the loopback and IKE IP ports.

When a tier-0 logical router is configured with DNAT, IPsec, and Edge firewall, traffic is processed in this order: IPsec first, then DNAT, and then Edge firewall.

On a tier-0 or tier-1 logical router, you can configure different types of ports. One type is called centralized service port (CSP). You must configure a CSP on a tier-0 logical router in active-standby mode or a tier-1 logical router to connect to a VLAN-backed logical switch, or to create a standalone tier-1 logical router. A CSP supports the following services on a tier-0 logical router in active-standby mode or a tier-1 logical router:
  • NAT
  • Load balancing
  • Stateful firewall
  • VPN (IPsec and L2VPN)