Configuration overrides can be made to some settings that were assigned to an Edge. In most cases, an override must first be enabled, and then changes can be made.
Override rules can be added to existing Business Policy and Firewall rules. Override rules have precedence over all other rules defined for Business Policy or Firewall. For more information, see Configure Business Policy for Edges .
Note: Edge overrides enable Edge specific edits to the displayed settings, and discontinue further automatic updates from the configuration Profile. You can simply turn off the override and go back to automatic updates any time.
Edge Device Configurations—A Roadmap
Go to Configure > Edges > Device to override configurations at the Edge-level. Some configurations are segment-aware, that is the configurations must be enabled for each segment where they are intended to work. Whereas, other configurations are common across segments.
The following table provides the list of Edge-level configurations:
| Configuration | Type of Configuration | For details, refer to ... |
|---|---|---|
| DSL Settings
Note: Available only for 610 Edge and 610-LTE devices.
|
Common | Configure DSL Settings |
| GPON Settings
Note: Available only for 6X0 Edges.
|
Common | Configure GPON Settings |
| Authentication Settings | Segment-aware (Only for Global segment) | Configure Authentication Settings |
| DNS Settings | Segment-aware (Only for Global segment) | Configure DNS Settings |
| NetFlow Settings | Segment-aware | Configure Netflow Settings for Edges |
| LAN-Side NAT Rules | Common | LAN-side NAT Rules at Edge Level |
| Syslog Settings | Segment-aware | Configure Syslog Settings for Edges |
| Static Route Settings | Segment-aware | Configure Static Route Settings |
| ICMP Probes | Segment-aware | Configure ICMP Probes/Responders |
| ICMP Responders | Segment-aware | Configure ICMP Probes/Responders |
| VRRP Settings | Segment-aware | Configure VRRP Settings |
| Cloud VPN | Segment-aware | Configure Cloud VPN and Tunnel Parameters at the Edge Level |
| BFD Rules | Common | Configure BFD |
| OSPF Areas | Segment-aware | Enable OSPF |
| BGP Settings | Segment-aware | Configure BGP from Edge to Underlay Neighbors |
| Multicast Settings | Segment-aware | Configure Multicast Settings |
| Cloud Security Service | Segment-aware | Configure Cloud Security Services for Edges |
| High Availability | Common | Activate High Availability |
| VLAN | Common | Configure VLAN for Edges |
| Loopback Interfaces | Segment-aware | Loopback Interfaces Configuration |
| Orchestrator Management Traffic | Common | Configure Orchestrator Management Traffic for Edges |
| Device Settings (Interface and WAN) | Common | Configure Device Settings |
| Security VNF | Common | Security VNFs |
| Multi-Source QOS | Common | Activate Multi-Source QOS |
| L2 Settings | Common | Configure Layer 2 Settings for Edges |
| SNMP Settings | Common | Configure SNMP Settings for Edges |
| NTP Servers | Common | Configure NTP Settings for Edges |
| Visibility Mode | Common | Configure Visibility Mode |
